特黄特色的大片观看免费视频

                <dl id="t1x99"></dl>
              <progress id="t1x99"><track id="t1x99"></track></progress><thead id="t1x99"><address id="t1x99"></address></thead>
              <dl id="t1x99"><ruby id="t1x99"><dl id="t1x99"></dl></ruby></dl>
                <nobr id="t1x99"><form id="t1x99"><track id="t1x99"></track></form></nobr><dl id="t1x99"></dl>

                Gravity casting vs Low pressure casting

                2020-01-01 10:11:58

                Aluminum gravity casting and aluminum low pressure casting are both metal mold casting processes or called permanent mold casting prosess. Both are used to produce aluminum castings. The molds are metal molds. Hot-working mold steel (such as H13) is used to make molds.


                Aluminum alloy gravity casting and aluminum alloy low-pressure casting process can produce the same cast aluminum alloy grades, aluminum liquid pouring temperature, mold opening time is similar, the resulting aluminum castings have similar compactness, strength and other mechanical properties.

                There are differences between aluminum alloy gravity casting and aluminum alloy low pressure casting in terms of forming principles, aluminum casting structure, labor intensity, number of batches, and development time, as shown in the following figure:


                Aluminum Castings

                Molding principle

                Aluminum casting structure

                Labor intensity

                Minimum lot

                Development time

                Mold cost

                Aluminum gravity casting

                Use of gravity

                Complex and diverse

                High

                100

                Short

                less

                Aluminum low pressure casting

                Use of air pressure

                single

                General

                500

                Long

                Higher

                 

                As can be seen from the comparison of the above figure, gravity casting of aluminum alloy is more suitable for the production of multiple varieties and small batches, with short development cycles and high quality requirements. Aluminum alloy low-pressure casting is suitable for the production of larger batches, thinner aluminum castings, and structures suitable for aluminum alloy low-pressure casting products, a long development cycle is conducive to the improvement of production technology in the production process.


                The typical product produced by the aluminum alloy low pressure casting process is an automobile wheel rim. The structure of this aluminum casting is very suitable for the structural characteristics of the low pressure casting process, and the production volume is very large. There is enough time to improve the production technology.


                The typical products produced by the aluminum alloy gravity casting process are industrial robot castings. These aluminum castings have small production batches, high product quality requirements, short development time, and need to produce high quality, non porous sand holes in a short period time of aluminum castings.


                特黄特色的大片观看免费视频

                              <dl id="t1x99"></dl>
                            <progress id="t1x99"><track id="t1x99"></track></progress><thead id="t1x99"><address id="t1x99"></address></thead>
                            <dl id="t1x99"><ruby id="t1x99"><dl id="t1x99"></dl></ruby></dl>
                              <nobr id="t1x99"><form id="t1x99"><track id="t1x99"></track></form></nobr><dl id="t1x99"></dl>